Dual clutches, 4 encoders, buttons and LED
Last updated
Last updated
Hold buton 1 and 2 together for 5 seconds to restart the controller and boot as storage device.
LEDs are running on 3.3V data in this diagram, which works up to a certain LED count. Limit is set to 30 because more is unlikely to work. For higher LED counts use a level shifter and set up a full DDC firmware.
Press button 3 for 4 seconds to initiate calibration mode. Release button, then press both clutches all the way in and release. Then press button 3 again once. Calibration completed.
Hold button 4 to adjust the bite point for your dual clutch launch. Encoder 1 will do increments of 10%, encoder 2 for 1% and encoder 3 for 0.1% increments.
Hold button 4 to change bite point preset with encoder 4, storing 12 different bite points.
Hold button 4 and pump one of the clutches to cycle through clutch modes.
Master clutch is the paddle that will give 100% clutch input when pressed completely in static mode. Slave paddle will stop at bite point. Master paddle will also work as throttle in brake/throttle mode.
